Aries-automotive 15600WRB Bedienungsanleitung PDF herunterladen

PARTS LIST:

Qty’s Description Qty’s Description

1 Winch receiver plate bracket 8 12mm Speed nuts

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Please NOTE: This part is an addition to part # AL15600 & will be installed on your JK after

(Steps 3 to 8 have been completed on new installs. If your JK already has the AL15600

installed please remove it and then follow (Step 10 for 2007-11 model years.) or Step 13 for

model years 2012-14 NOTE: Cutting of the factory air pump bracket will need to be performed for

relocation & fitment of the 15600WRB for model years 2012-14 (Step 13 for reference)

3. Start by removing front plastic skid shield from under the vehicle, using a flat tip screwdriver pry and

remove the plastic push pins holding the skid shield, seen in (Fig 1 & 1A)

4. Once removed start to remove the top plastic cover there are 2 push pins holding the plastic cover

in front of the grill, as seen in (Fig 2) with the plastic push pins removed, slide the cover to the left

side to allow for access of the inner nuts holding the bumper onto vehicle, as seen in (Fig 3 & 3A),

once done continue to remove driver side by sliding plastic to the right side (Fig 4 & 4A) shows

location of nuts to be removed.

Page 1 of 6

INSTALLATION INSTRUCTIONS

2007-14 WRANGLER WINCH RECIEVER PLATE BRACKET FOR AL15600

PART # 15600WRB

Photo of parts shown for reference

Winch receiver

late

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

PARTS LIST: Qty’s Description Qty’s Description 1 Winch receiver plate bracket 8 12mm Speed nuts PROCEDURE: 1. REM

Seite 2

5. Once inner nuts are removed begin to unplug the road lights from the factory wire harness, and unclip the harness from the bumper cover, as seen i

Seite 3

mounting to the factory bumper brackets, as seen in (Fig 8) Snug but do not tighten hardware, Plug in the road lights with the wire harness and secure

Seite 4

Page 4 of 6 Fig 4A Unplug wire harness from lights and

Seite 5

0 Page 5 of 6 Fig 9 Fig 8 Secure bumper per side wit

Seite 6 - Fig 10 Fig 10A

Page 6 of 6 Fig 9A Fig 11 Remove factory bracket by cutting it off with a grinder & cut off wheel Fi

Kommentare zu diesen Handbüchern

Keine Kommentare

Aries-automotive 15600WRB Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Aries-automotive 15600WRB herunter. Aries Automotive 15600WRB User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Aries-automotive 15600WRB